Like most regulations based on the UN Recommendations for the Transport of Dangerous Goods, Canada’s “Transportation of Dangerous Goods Regulations” (TDG) includes a number of exemptions. These provide easier and more cost-effective ways for shipping low-risk materials. However, each exemption needs to be carefully studied. If you don’t comply with all the requirements, you are not entitled to any part of the exemption.
One of the most misunderstood exemptions in TDG is found in section 1.16, the “500 Kilogram Exemption.” The provisions in this section originated in a long-ago series of permits intended to make shipment of small quantities of dangerous goods easier. Over the years, changes to this section have reduced its effectiveness; it still may be a helpful exemption in certain specific cases, but it must be used appropriately.
The first myth about the 500 kilogram exemption is that it is a total exemption from all requirements of TDG. This is far from the truth. At best, the exemption relieves the shipper from Part 3 (Documentation), Part 4 (Dangerous Goods Safety Marks) and Part 5 (Means of Containment). All other requirements of TDG will still apply. This includes, for example, the requirement that the carrier and all handlers must be TDG-certified. At one point, receivers were exempted from Part 6, Training, but this relief was removed in an amendment several years ago.
Obviously, the exemption only applies Continue Reading…